Bosch KDN64VL20N Frigo-congelatore da libero posizionamento Inox look - Manual (Page 9)

en
9
1. Position the appliance in the intended
installation area.
2. Unscrew the two screws on the base
panel and inspect the base panel.
3. Screw the front feet out until they
stand firmly on the ground and align
the appliance at the front.
4. Use a spirit level to check that the
appliance is horizontal.
5. Position the base panel and secure it
in place using the screws.
Note
The front feet must stand firmly on the
ground so that the appliance does not
roll away.
Connecting the
appliance
After setting up the appliance, wait for at
least one hour before starting the
appliance up. The oil contained in the
compressor may have been displaced
into the refrigeration system during
transport.
Before starting the appliance up for the
first time, clean its interior (see section
“Cleaning the appliance”).
Electrical connection
The socket must be near to the
appliance and easily accessible after the
appliance has been installed.
The appliance conforms to protection
class I. Connect the appliance to a
220-240 V/50 Hz alternating current
supply using a socket with protective
earthing conductor which has been
correctly installed. The socket must be
protected by a fuse with a rating of 10 A
to 16 A.
In the case of appliances operated
outside of Europe, check whether the
voltage and type of current specified
conform to the values of your electricity
grid. You will find this information on the
rating plate. Figure *
m
Warning
The appliance must never be connected
up to an electronic energy-saving socket.
Sinusoidal-commutated and line-
commutated inverters can be used with
our appliances. Line-commutated
inverters are used with photovoltaic
systems that are connected directly to
the national grid. Sinusoidal-
communicated inverters must be used
with standalone applications (e.g. on
ships or mountain huts) that do not have
a direct connection to the national grid.
Attaching handles
Figure '
Only attach the handles once the
appliance has been positioned in its
installation location and has been
aligned so that it is level.
1. Push the holders into the guides.
2. Position and tighten the screws.
3. Push the handles onto the holders and
slide them downwards. The "Top"
sticker must be facing upwards.
4. Position and tighten the screw.