ARRI Projection HDTV - Manual (Page 27)

27
4.4.4 Command Line Interface Syntax
Frames on a disc recorder can be accessed by the
alexpose command as files, using the protocol-like
filename convention:
‘dr://<host name>/<partition name>/<clip
name>/<frame number>
‘
e.g.
‘dr://mydiscrecorder/PART1/testclip/42‘
means frame 42 within the clip testclip. Frame
enumerations starts with frame 0.
Omitting the clip name addresses the complete
partition, e.g.
‘dr://mydiscrecorder/PART1/500‘
Note : This is a name convention built in the CLIF and
ALGUI software, not a protocol. Therefore, no
extra drives have to be installed to use this
feature.
Although the DVS software allows the creation
of partition and clip names containing ‘/‘ or
‘\‘, these will not work. The reserved clip
name ‘.‘ (a single dot) shall also be avoided.
Configuration
4.4.4.