ATEN ACS-1208L - Manual (Page 11)

Installation
Before you Begin
1. Make sure that power to all the devices you will be connecting
up have been turned off.
2. To prevent damage to your equipment due to ground potential
difference, make sure that all devices on the installation are properly
grounded. Consult your dealer for technical details, if necessary.
Single Station Installation
In a Single Stage installation, there are no additional Master View’s daisy
chained down from the first unit. To set up a single stage installation do the
following:
1. Use connector cable sets (as described in the Cables section on p. 3), to
connect any available CPU Port to the Keyboard, Video and Mouse ports of
the computer you are installing.
Note: Ignore the Daisy Chain Port at this time. It is only used when daisy
chaining additional Master View units. Daisy chaining is described in
the next section.
2. Plug the power adapter cable into the Master View’s Power Jack, then plug
the power adapter into an AC power source.
3. Turn on the power to the computers.
2002-01-15
ACS-1208L / ACS-1216L User Manual 7