ATEN ACS-1208L - Manual (Page 28)

(F4 ADM: continued)
Setting Function
SET QUICK
VIEW PORTS This function lets the Administrator select which Ports to include as
Quick View ports.
w To select/deselect a port as a Quick View Port, Double Click the
port you want, or use the Navigation Keys to move the highlight
bar to it, then Press [Enter].
w When a port has been selected as a Quick View Port, an
arrowhead displays in the QV column of the LIST on the Main
Screen to indicate so. When a port is deselected, the
arrowhead disappears.
w If one of the Quick View options is chosen for the LIST view
(see F2 LIST, p. 19), only a Port that has been selected here
will display on the List.
w If one of the Quick View options is chosen for Auto Scanning
(see SCAN/SKIP MODE, p. 21), only a Port that has been
selected here will be Auto Scanned.
The default is for no ports to be selected.
SET
ACCESSIBLE
PORTS This function allows the Administrator to define User access to
the computers on the installation on a Port-by-Port basis. For
each User, select the target Port; then press the [Spacebar] to
cycle through the choices: F (Full access), V (View Only), or
blank. Repeat until all access rights have been set, then press
[Enter]. The default is V for all users on all Ports.
Note: A blank setting means that no access rights are granted.
The Port will not show up on the User’s LIST on the Main Screen.
RESET
STATION IDS If you change the position of one of the Stations in the daisy chain,
the OSD settings will no longer correspond to the new situation.
This function directs the OSD to rescan the Station positions of the
entire installation and updates the OSD so that the OSD Station
information corresponds to the new physical layout.
Note: Only the Station Numbers get updated. Except for the Port
Names, all Administrator settings (such as Set Accessible Ports,
Set Quick View Ports, etc.), for all of the computers affected by
the change, have to be manually redone.
2002-01-15
24 ACS-1208L / ACS-1216L User Manual