Ransburg DynaFlow Programmers Manual - Manual (Page 42)

Command T
ype (hex)
Response Or
Action From User Interface
Response Or
Action From Interface Module
See
Types <02> and <09> to see what information is transferred.
Parameters Numbers: Job Parameters: <00> = Ratio <01> = Flow Set Point <02>
=
Maximum
Flow
<03> = Minimum Flow <04> = Pot Life
Timer
Master Channel V
ariables:
<0A> = MVR High <0B> = MVR Low <0C> = Pulses Per Liter <0D> = Dead Band <0E> = Proportional Gain <0F> = Integral Gain <10> = Derivative Gain Slave Channel V
ariables:
<14> = MVR High <15> = MVR Low <16> = Pulses Per Liter <17> = Dead Band <18> = Proportional Gain <19> = Integral Gain <1A> = Derivative Gain Hidden V
ariables:
<20> =
Algorithm Number
<21> = PID Update
Time
<22> =
Auto-tune Procedure Number
<23> = Proportional Part of V
oltage Output
<24> = Integral Part of V
oltage Output
<25> = Derivative Part of V
oltage Output
<26> = Closed-Loop Proportional Gain <27> = Closed-Loop Integral
Time
<28> = Closed-Loop Dif
ferential
Time
<29> = Open-Loop Proportional Gain <2A> = Open-Loop Integral
Time
<2B> = Open-Loop Derivative
Time
<2C> = Closed-Loop Ultimate Gain <2D> = Closed-Loop Ultimate Period <2E> = Open-Loop Delta V
oltage Output
<2F> = Open-Loop Delta Fluid Flow <30> = Open-Loop Calculated Slope <31> = Open-Loop
Time for Calculated Slope
<32> = Open-Loop
Time Lag
<33> = Filter <34> = Control W
ord
38
DynaFlow Programer's Manual - Introduction
Ransburg
LN-9406-00.3