Ransburg Vector R Series Classic 79520 R90 Waterborne - Manual (Page 62)

Vector R Series Classic Applicators - Parts Identification
58
Ransburg
AH-06-02.12
4. Carefully score the outer jacket linearly and
then radially approximately 18-inches back from
the cut end. Split the outer jacket along the lin-
ear score mark and peel it away from the inner
sheath. Then remove the jacket completely by
tearing along the radial score mark.
5. Lightly score the inner sheath linearly and then
radially 1-inch from the outer jacket. Split the in-
ner sheath along the linear score mark and peel
it away from the core fluid hose. Then remove
the sheath completely by tearing along the radial
score mark.
6. Roll the inner sheath back over itself until it
touches the outer jacket.
7. Cut approximately 1/4-inch of inner sheath off.
NOTES
† Special care must be taken when remov-
ing the sheathing from the fluid hose. Make
sure all tools are very sharp and only score
the surface of the sheath. Inserting the knife
too deep can score the surface of the core
material and lead to pin-holing and failure of
the hose.
W A R N I N G !