Inst, Mounting – Ransburg RCS-100FP Fluid Pump Kit 70945 User Manual
Page 10
LN-9227-00
INST
INST
INST
INST
INSTALLA
ALLA
ALLA
ALLA
ALLATION
TION
TION
TION
TION
Fluid Pump Motor Speed Control Station - Installation
6
6
6
6
6
>
The user MUST read and be familiar
with the section on SAFETY in this
manual and the ITW Ransburg safety
literature therein identified.
W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
!!!!!
MOUNTING
MOUNTING
MOUNTING
MOUNTING
MOUNTING
The controller may be mounted either vertically
or horizontally. However, never mount the
controller upside down, immediately beside or
above heat generating equipment, or directly
below water or steam pipes.
>
The control unit MUST be located
outside the hazardous area.(See NFPA
No.33).
W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
!!!!!
The controller must be mounted in a location
free of vibration.
Multiple controllers may be mounted side by
side, as close to each other as the mounting
feet will allow.
The minimum clearance at the top and bottom of
the controller may be as narrow as the conduit
fittings allow.
The atmosphere surrounding the controller must
be free of combustible vapors, chemical fumes,
oil vapor, and electrically conductive or corro-
sive materials.
Figure 1: Mounting Dimensions
Figure 1: Mounting Dimensions
Figure 1: Mounting Dimensions
Figure 1: Mounting Dimensions
Figure 1: Mounting Dimensions