Ransburg RCS-100FP Fluid Pump Kit 70945 - Manual (Page 6)

LN-9227-00
Fluid Pump Motor Speed Control Station - Safety
AREA AREA AREA AREA AREA
Tells where
hazards may occur.
HAZARD HAZARD HAZARD HAZARD HAZARD
Tells what the hazard is.
SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS
Tells how to avoid the hazard.
Spray Area Spray Area Spray Area Spray Area Spray Area
2 2 2 2 2
Fire Hazard
Improper or inadequate opera-
tioning and maintenance proce-
dures will cause a fire hazard.
Protection against inadvertent
arcing that is capable of causing
fire or explosion is lost if any
safety interlocks are disabled
during operation. Frequent
power supply shutdown indicates
a problem in the system requir-
ing correction.
Fire extinguishing equipment must be present in
the spray area and tested periodically.
Spray areas must be kept clean to prevent the ac-
cumulation of combustible residues.
Smoking must never be allowed in the spray area.
The high voltage supplied to the atomizer must be
turned off prior to cleaning, flushing or mainte-
nance.
When using solvents for cleaning:
Those used for equipment flushing should have
flash points equal to or higher than those of the
coating material.
Those used for general cleaning must have flash
points above 100
°
F (37.8
°
C).
Spray booth ventilation must be kept at the rates
required by NFPA 33, 1995 Edition, OSHA and
local codes. In addition, ventilation must be main-
tained during cleaning operations using flammable
or combustible solvents.
Electrostatic arcing must be prevented.
Test only in areas free of combustible material.
Testing may require high voltage to be on, but only
as instructed.
Non-factory replacement parts or unauthorized
equipment modifications may cause fire or injury.
If used, the key switch by-pass is intended for use
only during set-up operations. Production should
never be done with safety interlocks disabled.
Never use equipment intended for use in waterborne
installations to spray solvent based materials.