Reese 37034 MULTI-FIT RECEIVER - Manual (Page 5)

2000-2006 TOYOTA TUNDRA :
1. Ream existing hole at the rear of the frame to except a 5/8” bolt and install the 5/8” bolts through the bolt plates and into
the frame. With the 3/8” spacer, 5/8” lock washer, and 5/8” nut bolt the brackets to the frame. Leave the bolts loose
enough to center bracket on frame of truck. Do not install fasteners in the forward hole in the brackets at this time.
2. Install the center section to the brackets as shown. Use the bolting location indicated. Install 1/2” bolts through the center
section and the bracket as shown. Install 1/2” lock washers and nuts on the bolts.
3. Using the forward most holes in the brackets as a guide drill a 5/8” hole and install the 5/8” bolts with 1/4” bolt plates
through the frame and brackets. Then install the 3/8” spacer, 5/8” lock washer, and 5/8” nuts.
NOTE: Be sure to use four holes to bolt the brackets to the center section.
4. Tighten the nuts in the following order:
First torque the 1/2" nuts to 70 ft•lb.
Then torque the 5/8" nuts to 115 ft•lb.
NOTE: SIDE BRACKETS MAY DEFLECT WHEN TIGHTENED
5/8” BOLT
1/4” BOLT PLATE
3/8” SPACER
5/8” LOCK WASHER
5/8” NUT
1/2” BOLT
1/2” NUT
1/2” LOCK WASHER
FRONT
REAR
TOOLS REQUIRED
15/16”
SOCKET
15/16”
WRENCH
3/4” SOCKET
3/4”
WRENCH
21MM SOCKET
TORQUE WRENCH
SAFETY GLASSES