Reese 44548 PROFESSIONAL RECEIVER - Manual (Page 2)

Installation Instructions
Lexus GX470
Toyota 4Runner
Part Numbers:
44548
75155
70779
1. Remove the (6) bolts holding the (2) fascia support brackets. Return the fascia support brackets and fasteners to
vehicle owner for reinstallation if hitch is removed. (Figure 3. above)
2. Install hitch per steps 1, 3,4 on above. Step 2 is for the Toyota 4Runner only.
3. Install the zip cable ties (4) (Fig. 4 below) through the spare tire bracket (attached to the impact bar,not the spare tire)
creating a large loop. Feed the remaining (2) zip cable ties through the fascia tabs then through the large loop
{securing the (2) zip cable ties together}.
Rev. E 9-15--08 N75155 Sheet 2 of 6 z 2006, 2007, 2008 Cequent Towing Products
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
FIGURE 3.
BACK SIDE of IMPACT BAR
Existing hex bolts,
M8 x 1.25
Fascia Support Bracket
LEXUS GX470 VEHICLES ONLY
LEXUS VEHICLES ONLY
FIGURE 4.
BACK SIDE of IMPACT BAR
Zip cable ties
typical both sides
1. Remove tow hook & electrical bracket (if present) from vehicle frame and return to owner with fasteners.
Note: If present, unplug wiring connector bracket from impact bar. Remove the two plastic wire holders that
hold the 7-way connector wires, and the plastic wire above the frame rail. This will allow the play needed to
move electrical plug.
2. On TOYOTA 4RUNNER Vehicles ONLY.- Trim fascia tabs (both sides) near the bottom of the impact bar as
needed. (As shown in Figure 2. Page 1).
3. Raise hitch into position, making sure the factory 7-way connector is above the crosstube of the hitch during
installation. Align side brackets with existing tow hook holes at end of frame rails. Install fasteners as
shown. (Figure 1. Page1)
4. Tape (1) 1/4” x 1” x 3” block to each handle-nut. Insert the handle-nut into slots located in the impact bar.
Install the 1/2”-13 hex bolt and 1/2” conical washer as shown. (Figure 1)
5. Place the factory 7-way connector into the electrical bracket provided on the hitch. Using (2) ¼” hex bolts
and flanged nuts, attach 7-way electrical plug to electrical bracket on the hitch.
Tighten all 1/2” GR5 Handle nut bolts with torque wrench to 50 Lb.-Ft (68N*M).
Tighten all M8 fasteners with torque wrench to 20 Lb.-Ft (27N*M).
Tighten all M12 fasteners with torque wrench to 68 Lb.-Ft (92N*M).