Reese 30081 SELECT SERIES 20K FIFTH WHEEL User Manual
Page 14
30081N-7 July10 F
PCN13787 ©2010 CEQUENT PERFORMANCE PRODUCTS, INC
LITHO IN USA
FOR KITS: 30081, 40261 & 50181
14
8.
Hitch height determination:
With trailer leveled and on level ground measure from the ground to the king pin box, “A” in Figure 17.
Secondly measure from the height of the inside of the truck bed, “B” in Figure 17. Dimensions “C” and “D” in
Figure 17 can be used to determine the amount of clearance over the side rails, as mentioned in Note 17.
Hitch Height = A
– B + 2”
The 2” value is an estimate of suspension compression due to king pin weight of the trailer. This
compression could range between 1”-5” depending on the truck being used and the trailer being towed.
D
– C + 2” > 6” as noted in Note 7.
B
D
C
A
*MEASURED WITH TRAILER LEVEL,
ON LEVEL GROUND
WARNING:
Connection for trailer wiring must be located at the side of the truck bed between the driver’s
seat and the rear wheel to prevent operators from working between the truck and trailer.
Avoid putting any part of your body under the trailer or between the truck and trailer.
Unexpected or accidental movement of the truck or the trailer can cause serious injury or death
If you must place any part of your body under the trailer or between the truck and trailer you
MUST perform ALL of the following steps:
Check that the truck transmission is in park
Check that the emergency brake is on
Block in front of and behind all trailer tires
Check that the trailer landing gear are resting on firm ground
9.
If a lube plate is to be used with a 5
th
Wheel Kit it must be at least 12” in diameter.
Cequent Performance
Products
offers this optional lube plate as part # 83001 / 40001.
Figure 17