Reese 30868 RAIL KIT - Manual (Page 9)

30868N – 9FEB11D PCN14805 ©2011 CEQUENT PERFORMANCE PRODUCTS, INC. LITHO IN USA
9
12. Using the drivers side edge of the bed corrugation, find the center of the truck bed. Measure the locations of the
holes that will need to be cut using Figure 20 (long bed application) or Figure 21 (short bed application). If a
plastic drop-in bed liner is used cut 19” X 4” slots in liner measured from center of holes in truck bed. If the REESE 
Elite  Series
slider fifth wheel assembly is used, then see fifth wheel slider assembly instructions for slot cut
dimensions.
Figure 21 – Short Bed (6’)
13. Remove 5/8” x 2“ bolts attaching frame bracket to mounting rails. Move rails rearward or forward to prevent
interference with hole drilling or punching of the truck bed.
Truck Bed
Tailgate
Figure 20 – Long bed (8’)
Tailgate
Truck Bed
3-1/4” DIA.
4 PLCS.
3-1/2” DIA.
3-1/4” DIA.
4 PLCS.
3-1/2” DIA.
42-3/8”
32-5/8”