Sentry Industries CA756 - Manual (Page 67)

100 101
Program area and calculation mode
specification in the WRT mode
Besides normal function calculations, to perform binary,
octal, decimal and hexadecimal calculations and
conversions, standard deviation calculations, and
regression calculations in a program, a calculation mode
must be specified. Program mode specification and
program area specification are performed at the same time.
First the WRT mode is specified ( ), and then a
calculation mode is specified. Next, the program area is
specified, and, when is pressed, the calculation mode is
memorized in the program area.
Henceforth, stored programs will be accompanied with the
calculation mode.
Memorizing the BASE-N mode in P2
As shown above, the calculation mode will be memorized
into a program area.
At this time, each press of a cursor key or will
cause the cursor to move to the next sequential step, For
example:
This unit contains a total of 10 program areas (P0 through
P9) for the storage of programs. These program areas are
all utilized in the same manner, and 10 independent
programs can be input .One main program (main routine)
and a number of secondary programs(subroutines) can
also be stored. The total number of steps available for
storage in program areas P0 through P9 is 400 maximum.
Specification of a program area is performed as follows:
RUN mode: Press any key from 0 through 9 after pressing
the key. Then press .
P0
P8
* In this mode, program execution begins when is
pressed.
WRT mode: Use or to move the cursor under
the program area to be specified and press .
Only the numbers of the program areas that do not yet
contain programs will be displayed. "-" symbols indicate
program areas which already contain programs.