SKC 223-Series PowerFlex - Five-station - Manual (Page 3)

3
Procedure for Charging Other SKC Pump Models
The following instructions apply to each charging port and sample pump used.
Each port operates independently.
1. Ensure the sample pump is off .
2. Select the appropriate pump-specifi c cable.
3. Insert the RJ-45 connector into a charging port on the PowerFlex. The connector
should slide easily into the port.
4. Insert the charging plug end of the cable into the charging jack on the
appropriate sample pump.
AirChek 52 Note: Plug the charging plug end of the cable into the jack on the
back of the batt ery pack.
222 Pump Note: Push the charging plug end of the cable into the charging jack
on the pump until it clicks. This may require some force.
5. The LED at the port containing the pump will light a steady red to indicate that
a charge sequence has been initiated. Batt eries for up to four diff erent pump models
can be charged simultaneously on the fi ve-station PowerFlex.
If the LED does not light to red in < 60 seconds, see Troubleshooting, Step 1.
6. Once the batt ery pack is fully charged, the LED at the port will change to a
steady green to indicate that PowerFlex has switched to a trickle charge to keep
the batt ery at full charge.
7. The batt ery can be removed at any time aft er the LED turns green. Detach the
batt ery from the cable and remove the cable from the charger.
Important Note: Remove pump-specifi c cable from charger when not in
use to avoid shorting.
Important Note: Pumps may remain connected to the charger indefi nitely
(without causing damage to the pump or charger).