SKC 225-2402 Sterile Surface Swab Kit - Manual

Surface Swab Kit
Cat. No. 225-2402
Operating Instructions
863 Valley View Road, Eighty Four, PA 15330 USA
Tel: 724-941-9701 Fax: 724-941-1369 e-mail: [email protected]
Form 38039 Rev 1302
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which provides
SKC’s sole liability and the buyer’s exclusive remedy. To view the complete SKC Limited
Warranty and Return Policy, go to htt p://www.skcinc.com/warranty.asp.
To the trained investigator, gross
contamination of building materials
is usually self-evident. However, it
is oft en useful to sample materials to
demonstrate the presence of elevated
levels, determine the relative degree
and type of biological contamination
in an area, and to verify remediation
procedures.
The Surface Swab Kit provides all the
necessary supplies to sample surfaces
for bioaerosols that are deposited
through contact or that sett le out of
the air onto surfaces where they can
be re-aerosolized and inhaled. This non-destructive method can be safely used on
most surfaces and materials. Rayon tip is inert, non-toxic, and permits good sample
retrieval and adsorption. Send samples to a qualifi ed laboratory for analysis.
Operation
1. Remove the sterile swab from its package aseptically.
2. Remove the sealing cap from the tube containing the sponge. Insert the swab
into the tube and moisten the swab tip by pushing it gently into the sponge.
3. Remove the swab from the tube. Using a rolling motion with the swab, gently
swab the desired area thoroughly. Templates are included in the kit for defi ned
area sampling.
4. Insert the swab into the tube, replace the sealing cap, and prepare for transport
to a laboratory.
Ordering Information
Description Cat. No.
Surface Swab Kit,* ea 225-2402
Surface Swabs Only,* pk/50 225-2400
* Limited shelf-life
For a list of laboratories that can perform microbiological analysis, go to
www.skcinc.com and click on the Laboratory List butt on.
Surface Swab Kit contains 10 sterile swabs in transport
tubes and 10 plastic templates (5 x 10 cm)