SKC Limited Sidekick MTX Pump Operating Instructions - Manual (Page 8)

Page 6 224-SMTXM Issue F www.skcltd.com
General Information
1) Pump Models
224-50MH Standard pump with simple on/off control. Non-intrinsically safe model.
224-51MTX Intermediate pump with simple on/off control. Intrinsically safe model.
224-52MTX Deluxe pump with simple on/off control and elapsed time display. Intrinsically safe model.
2) Care of Sidekick Series Pumps
• Always use the correct SKC batteries and battery chargers designated for the Sidekick series pumps.
• Never run the pump long term without a tube or filter medium in place.
• When carrying out sampling using long term colour change tubes always use a tandem tube holder with trap tube
(Part No. 222-3D-2 and cover 224-29T). This will prevent the aggressive fumes generated by these tubes from
entering and damaging the pump mechanism.
• When carrying out sampling using impingers always fit a trap between the impinger and pump inlet. This will prevent
the possibility of the fluid used in the impinger from entering and damaging the pump mechanism. As a further
precaution always ensure that the pump flow rate is set to below 1 litre/min before connecting the trap and impinger
to the pump inlet. For stability use the accessory mounting screws (refer to pump diagram on pages 8 and 9) to fix
the impinger bracket to the front of the pump.
• The Sidekick series pump cases are IP20 rated, they are not rated as water or splashproof and therefore must not be
used where it is possible for water to enter the pump casing.
• Sidekick pumps are fitted with a particulate filter which is easy to replace. This is situated under the hose connector,
which has a screw fitting. For general maintenance replace the filter every 2-3 months or if it appears dirty. New filters
are white in colour (order Part No. P40370).
Warning - Failure to follow these guidelines will void the product warranty.