ADC ACE-COM L1 - Manual (Page 16)

Installation LTPH-UM-1088-02, Issue 2
6 January 3, 2002 ThinMux Chassis
M
OUNTING THE
C
HASSIS
Figure 2. ThinMux Chassis in a CO Rack
1 Install a mounting bracket on each side of the ThinMux chassis using the
three screws provided for each bracket (8-32 x
5 /
16
screws) as shown in
Figure 2 . (Mounting brackets and screws are contained in the installation
kit.)
2 Install ESD input bracket on front left side of the chassis.
3 Align the chassis mounting bracket holes with the rack’s vertical
mounting holes. Mount the chassis in the rack. Install two
12-24 x
1 /
2
screws in each bracket and secure the chassis to the rack.
Two sets of mounting brackets are supplied to fit 19-inch or
23-inch racks with standard EIA-hole spacing (1/2 inch).
Optional brackets with WECO-hole spacing (1 inch) are
available (ACE-MK1).
CO rack
Two 12-24 x / screws 1 2
Three 8-32 x / screws 5
ESD input bracket
Two 6-32 x / screws 1
4
Three 8-32 x / screws 5
16
Mounting brackets
Two 12-24 x / screws 1
2
16