Apple MacBook Pro 17-inch (original, Core 2 Duo, 2.4GHz, Late 2007 CTO, Early 2008, and Late 2008) - Manual (Page 177)

MacBook Pro 17-inch (original, Core 2 Duo, 2.4/2.6GHz, 2008) Troubleshooting — Hardware Symptom Charts 177
Replace the Bluetooth card. 5.
Replace the logic board. 6.
Bluetooth card not recognized by other devices
Open Bluetooth in System Preferences and make sure that Discoverable is checked under 1.
the Settings tab.
Make sure the Bluetooth antenna is properly installed. 2.
Check that the Bluetooth antenna is connected to Bluetooth card. 3.
Replace with known-good Bluetooth card. 4.
Replace logic board. 5.
Display
Display latch not working
Note: As the display is being closed, two latch hooks in the top of the display housing should be
magnetically pulled down through the slots in the top case and secured by the latch mechanism.
When the latch button is pushed, the hook should release and retract into the display housing.
See Latch Adjustment chapter for more information on adjusting the latch mechanism.
If one or both of the latch hooks are broken, replace the display latch hook assembly.
When displaying a single color over the screen area, the LCD panel shows one or
more pixels that are not properly lit
To determine whether or not the display has an acceptable number of pixel anomalies, follow the
steps below:
Set the display image to one of the following colors: all-white display, all-red display, all-green 1.
display, or all-blue display. Knowledge Base article 112125: Service Diagnostics Matrix, has the
LCD Tester Diagnostic Utility that will generate these patterns on the screen.
Using a jeweler’s loupe, pocket microscope, or other magnifying device, identify and count 2.
each pixel anomaly:
• Bright subpixel anomaly = subpixel that is always on
• Dark subpixel anomaly = subpixel that is always off
Acceptable Number of Subpixel Anomalies
Bright Up to 3
Dark Up to 5
Combination Up to 7