IAI America RCS2-GR8 User Manual
Page 30
2. Installation
24
2.3.2 Installation
[1] Installation of the Main Unit
There are T-shaped grooves for M6 on the right and left of the base. Utilize these T-slots for the
attachment of bracket and other equipments by putting in nuts and tightening with screws.
Nut
M6 T-nut (recommended) or square nut
Screw M6�8
(Note 1)
Note1 Thread length should be 8mm maximum due
to the T-slot depth. Select a screw with a
thread length that is equivalent to the
thickness of screw seat on the attached part
+ 8mm.
[2] How to a Insert Nut
To insert a nut to the T-slot, the side cover needs to be removed.
1)
Remove the screws securing the side cover.
2)
Slide the side cover in the arrow direction to take off.
3) Put a nut in the T-slot, and slide in the side cover to the opposite direction of the arrows to put
back.
4) Tighten the screws.
Detail A
Screw
Side Cover