IAI America RCS3PCR-SS8C - Manual (Page 142)


11. Maintenance and Inspection
131
13) Tighten the screw on the coupling.
14) Slightly move the slider to expose the second screw on the coupling, and tighten the screw in the same
manner.
Tighten the screw on the
coupling using an Allen wrench
of 2.0 mm across flats.
Slightly move the slider.
Tighten the screw on the
coupling using an Allen wrench
of 2.0 mm across flats.
15) Detach the screws on the end cap in the actuator cable for replacement with a phillips screwdriver.
Affixing bolts at attached cable end
(Cross recessed screws)
Affixing bolts on motor-end cap
(Cross recessed screws).