IAI America LSAS-N15HM - Manual (Page 67)

13. Replacement/Adjustment of Stainless Sheet
51
13.1.2 Adjusting the Stainless Sheet Tension
[1] First, affix the stainless sheet uniformly on the right and left in a manner free from meandering.
(The stainless sheet is held in position by the attraction forces of magnets. Therefore, lift the sheet
from one end and then put it back in place toward the same end to achieve better result. Also
adjust the stainless sheet from the slider center toward both ends.)
[2] Move the slider to a position near the stroke center, and remove the stainless-sheet retainer plate
on either side.
[3] Adjusting the Stainless Sheet Tension
Remove the inspection cover located on one side of the slider cover to reveal the interior of the
slider.
Adjust the sheet in the axial direction uniformly on the right and left until the height of the apex of the
slider curve comes to 1.4 mm and 1.3 mm below the installation surface of the slider cover for
N10SS or N10SM, and N15SS, N15SM, N15HS or N15HM, respectively. In this position, loosely
tighten the mounting screws on the sheet retainer plate (hexagonal socket head button bolt M4 x 10).
Move the slider to a position near the stroke center.
Remove the stainless-sheet retainer plate on either side.
N10SS, N10SM Clea
ran
ce
= 1.4 mm
N15SS, N15SM N15HS, N15HM Clea
ran
ce
= 1.3 mm