IAI America LSAS-N15HM User Manual
Page 71
13. Replacement/Adjustment of Stainless Sheet
55
2)
Remove the retainer screws of the old stainless sheet, and pull out the stainless sheet to remove it
completely.
3)
Place the new stainless sheet through the stainless sheet retainer plates.
4)
Mount the stainless sheet in place with the retainer plates and the mounting screws.
At this time, mount only the home position side, and loosen the side opposite to the home position
side.
5)
Install the clearance check jig.
Right
Home side *
Stainless sheet retainer plate
Mount the stainless steel sheet retailer plates and the mounting
screws only on the home position side, and loosen the side
opposite to the home position side.
* In the above figure, the right side shows the home
position when the cable is placed at the top.
Outside openings
Center opening
Mount the clearance check jig
in place of the slider cover.