ID Innovations Bar code Mini Decoder - Manual (Page 17)

Features
17
MSI/PLESSEY: Laser/CCD Redundancy: ON <> 
Use this option to control the Laser/CCD redundancy for MSI/PLESSEY bar codes. This option provides additional security
when scanning poorly printed or damaged bar codes.
Note: Using this option does not require you to physically read the same bar code twice to get a good read. The scanner
continuously sweeps across the bar code the number of times necessary when this mode is enabled, therefore requiring no
additional operator intervention.
Select Option Group: CODE 11 GROUP
Select this option group to modify the individual settings for the CODE 11 decoder. Once you have selected this option group,
you may cursor down to configure each of the following decoder options.
CODE 11: Decoder: ON
<> 
Use this option to enable or disable the CODE 11 decoder. The default for this option is ON.
CODE 11: Check Digit: MOD 11
<> 
MSI/PLESSEY bar codes can contain a few different combinations of check digits. Use this option to configure the
combinations of check digits, choose from "MOD 11" or "MOD 11, MOD 11".
CODE 11: Send Check Digit: OFF
<> 
Use this option to have the decoder either send the FIRST, FIRST & SECOND, or No (OFF) check digit to the computer.
CODE 11: Maximum Length: 83
<>
CODE 11: Minimum Length: 2 <> 
Use these options to configure the minimum and maximum lengths of CODE 11 bar codes that can be read. If you configure
the Maximum Length to 10 characters and the Minimum Length to 5 characters, the decoder will not read CODE 11 bar codes
with less than 5 characters and more than 10 characters.
<>
CODE 11: Type ID: m DEC 109 HEX 6D ASCII ALT 
Use this option to configure the Type ID for the CODE 11 bar code. Type ID's can be transmitted as a prefix or a suffix to the
bar code data, for more information see OTHER: Send Bar Code Type ID on page 18.
CODE 11: Laser/CCD Redundancy: OFF
<> 
Use this option to control the Laser/CCD redundancy for CODE 11 bar codes. This option provides additional security when
scanning poorly printed or damaged bar codes.
Note: Using this option does not require you to physically read the same bar code twice to get a good read. The scanner
continuously sweeps across the bar code the number of times necessary when this mode is enabled, therefore requiring no
additional operator intervention.
Select Option Group: LASER/CCD GROUP
Select this option group to modify the individual settings for LASER/CCD operation. Once you have selected this option group,
you may cursor down to configure each of the following decoder options.
LASER/CCD: Operating Mode: SINGLE SCAN
<> 
The decoder can be set to operate in one of seven modes when used with a Laser/CCD scanner:
SINGLE SCAN
Once you press the trigger, the scanner is activated until a bar code is read, the Laser/CCD Timeout is
reached, or the trigger is released.
SINGLE SCAN NO TRIGGER
Once you press the trigger, the scanner is activated until a bar code is read or the Laser/CCD Timeout is
reached. Releasing the trigger does not end scanning.
MULTI-SCAN
Once you press the trigger, the scanner is activated and will continue to read bar codes until the trigger is
released or the Laser/CCD Timeout is reached.
MULTI-SCAN NO TRIGGER
Once you press the trigger, the scanner is activated and will continue to read bar codes until the Laser/CCD
Timeout is reached. Releasing the trigger does not end scanning.