Show ipx interface, Command mode, Description – Avaya P580 User Manual
Page 304: Syntax, Sample output, Systems, Show ipx interface -38
Chapter 13
13-38
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
show ipx interface
Command Mode
User.
Description
Displays the details of IPX interfaces configured on the switch.
Syntax
show ipx interface [<intf-name>]
Sample Output
The following is an example of the of the output that displays after you
enter the show ipx interface command.
10005129 is up, and administratively up
On vlan ipxServer, is up
IPX address is 10005129.02:e0:3b:d4:48:03,
encapsulation type Ethernet SNAP
MTU is 1492 bytes
Delay of this Novell network, in ticks, is 1
IPX Type 20 propagation packet forwarding
mode is set to Inbound
IPX RIP is enabled on this interface
IPX RIP periodic update packets have an
interpacket gap of 55 msec
IPX RIP updates are sent with up to 50
networks per packet
Sending of IPX RIP triggered updates is
enables
IPX RIP update interval is 60 seconds
IPX RIP aging interval multiplier is 3
.
.
.
Systems
P550R, P580, P880, and P882.
Table 13-19. Parameters, Keywords, Arguments
Name
Definition
<intf-name>
The name of the interface to show.