Ip ospf as-boundary-router, Command mode, Description – Avaya P580 User Manual
Page 388: Syntax, Systems, Ip ospf as-boundary-router -12
Chapter 19
19-12
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
ip ospf as-boundary-router
Command Mode
Global Configuration.
Description
* Important:
This command is not supported by v6.0 and later
application software.
Version 6.0 and later application software automatically detects the ASBR
status:
■
If route redistribution filters are configured for OSPF, the ASBR
status is enabled.
■
If all interfaces on the switch are in an OSPF stub area, the ASBR
status is disabled, regardless of whether route redistribution filters are
configured.
For more information on route redistribution filters, see “Configuring Route
Redistribution” in Chapter 12, “Configuring IP Routing” of User Guide for
the Avaya P580 and P882 Multiservice Switches, Software Version 6.1.
In earlier versions of application software, this command specifies if the
router is an autonomous-system boundary router (ASBR). Use the no form
of this command to disable ASBR status. The default state is disabled.
Syntax
Systems
P550R, P580, P880, and P882.
To Enable:
ip ospf as-boundary-router
To Disable:
[no] ip ospf as-boundary-router