Ip ospf hello-interval, Command mode, Description – Avaya P580 User Manual
Page 394: Syntax, Sample output, Systems, Ip ospf hello-interval -18
Chapter 19
19-18
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
ip ospf hello-interval
Command Mode
Interface Configuration.
Description
Specifies the hello interval time. The hello interval time is the time between
hello packets that the router sends on the interface. The value range is 1 to
65535. The default setting is 10. The no command restores the default
setting.
Syntax
Sample Output
The following command sets the Hello interval time to 60 seconds.
(config-if:intf3)#
ip ospf hello-interval 60
Systems
P550R, P580, P880, and P882.
To Configure:
ip ospf hello-interval <seconds>
To Restore Default:
[no] ip ospf hello-interval
Table 19-13. Parameters, Keywords, Arguments
Name
Definition
<seconds>
Unsigned integer that specifies the interval in seconds. The value
must be the same for all nodes on a specific network. The value
range is 1 to 65535. The default setting is 10.