Ip access-list, Command mode, Description – Avaya P580 User Manual
Page 425: Syntax, Systems, Ip access-list -11
Document No. 10-300090, Issue 1
20-11
Policy
ip access-list
Command Mode
Global Configuration.
Description
Creates a rule in an access control list (ACL). The rule that you set is
applied on all of the ports on the switch.
* Note:
You must enable the ACL on which you want to set a rule. Only
one ACL can be enabled at a time.
The no command deletes an ACL rule or ACL.
Syntax
This command performs the same operation as the
command.
See that command for explanations of the keywords and variables and for
examples.
Systems
P550R, P580, P880, and P882.
To Create a
Standard
ACL Rule:
ip access-list <access-list-name> <access-list-index>
{permit [{use-priority <priority> | use-diffserv [mask] |
remark-diffserv <dscp> [mask] | use-l2}] | deny | fwd1 |
fwd2 | fwd3 | fwd4 | fwd5 | fwd6 | fwd7 | fwd8}
{<source-ip-addr> <source-wildcard> | any | host
<source-ip-addr>}
To Create an
Extended
ACL Rule:
ip access-list <access-list-name> <access-list-index>
{permit [{use-priority <priority> | use-diffserv [mask] |
remark-diffserv <dscp> [mask] | use-l2}] | deny | fwd1 |
fwd2 | fwd3 | fwd4 | fwd5 | fwd6 | fwd7 | fwd8}
<protocol-id> {<source-ip-addr> <source-wildcard> |
any | host <source-ip-addr>} [{lt <port> | eq <port> |
gt <port> | range <port> <port>}] {<dest-ip-addr>
<dest-wildcard> | any | host <dest-ip-addr>} [{lt
<port> | eq <port> | gt <port> | range <port> <port>}]
[established]
To Remove an
ACL Rule or
ACL:
no ip access-list <access-list-name> [<access-list-
index>]