Set port auto-flush, Command mode, Description – Avaya P580 User Manual
Page 438: Syntax, Sample output, Systems, Set port auto-flush -6
Chapter 21
21-6
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
set port auto-flush
Command Mode
Global Configuration.
Description
When auto-flush is enabled and the link to a port fails, all entries in the
address forwarding table that were learned for this port will be marked
invalid. The default value for auto-flush is disabled.
Syntax
Sample Output
The following example enables auto-flush for port 2, on module 4.
(configure)#
set port auto-flush 4/2 enable
Port auto-flush set successful: 4/2.
Systems
P550R, P580, P880, and P882.
To Enable:
set port auto-flush {<mod-num> | <mod-swport-range>}
[...,{<mod-num> | <mod-swport-range>}] enable
To Disable:
set port auto-flush {<mod-num> | <mod-swport-range>}
[...,{<mod-num> | <mod-swport-range>}] disable
Table 21-4. Parameters, Keywords, Arguments
Name
Definition
<module-number>
The module number on which you want to set auto-flush.
Auto-flush can be set at the module level or port level.
<mod-swport-
range>
The port, or port range on which you want to enable auto-
flush.