Set port network-error-detection, Command mode, Description – Avaya P580 User Manual
Page 462: Syntax, Set port network-error-detection -30
Chapter 21
21-30
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
set port network-error-detection
Command Mode
Global Configuration.
Description
Configure network error detection and recovery (NEDR) for a port or ports.
Syntax
To Enable:
set port network-error-detection <mod-port-range> [action
{notify | disable-port}] [rising-threshold <rising-threshold-
value>] [falling-threshold <falling-threshold-value>]
[interval <interval seconds>]
To Disable:
network-error-detection {<mod-port-range> | all} action
off
Table 21-26. Parameters, Keywords, Argument
Name
Definition
<mod-port-range>
The slot number of the module, and, either port number,
or range of port numbers. Enter the port ranges in the
format Px-Py. For example:
• To specify port 1 on the module in slot 3, enter 3/1.
• To specify ports 1 through 5 on the module in slot
3, enter 3/1-5.
all
Disables NEDR on all ports on all modules in the switch.
all can be used only with off.
action {notify |
disable-port | off}
Action that NEDR performs when the rate of errors
exceeds the threshold. The options are:
• notify - Logs the event in the event log
• disable-port - Disables the port and logs the event
in the event log.
Note:
A port will be disabled if the rate of errors equals
or exceeds the threshold. Make sure a redundant
protocol is configured.
• off - Disables NEDR on the port or ports that you
specify.
The default setting is notify.
1 of 2