Avaya P580 - Manual (Page 47)

Document No. 10-300090, Issue 1 3-7
Appletalk
appletalk cable-range
Command Mode Interface Configuration.
Description Configure a cable range for an Appletalk Phase II for an interface. The no
form of this command disables Appletalk for this interface.
Syntax
Sample Output The following example configures a cable range of 222-224 for the
Appletalk interface on serial port 0.
(config-if:serial0)# appletalk cable-range 222.244
Systems P550R, P580, P880, and P882.
To Enable: appletalk cable-range <cable-range> [<network.node>]
To Disable: [no] appletalk cable-range
Table 3-5. Parameters, Keywords, Arguments
Name Definition
<cable-range> An optional parameter to indicate the range of the Appletalk
network values to be used on this interface. Specify start
and end values between 0 and 65279 and separate the values
with a hyphen.
The starting network number must be less than the ending
network number. When <cable-range> is omitted, the
interface tries to configure the Appletalk network and
obtains its configuration from another Appletalk router.
<network.node> The Appletalk network address to assign to the interface.
When <network.node> is omitted, the Appletalk address
defaults to 0.0.
• network - A 16-bit network number between 0 and
66279.
• node - An 8-bit node number between 0 and 254.