Set radius authentication source-ip, Command mode, Description – Avaya P580 User Manual
Page 534: Syntax, Sample output, Systems, Set radius authentication source-ip -8
Chapter 24
24-8
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
set radius authentication source-ip
Command Mode
Global Configuration.
Description
Sets the IP interface address the switch will use as the source IP address in
the Access Request messages. This value must be an IP interface address on
the switch. If set, and the IP interface becomes disabled, RADIUS will not
function because the switch will not be able to send or receive RADIUS
messages.
If left 0.0.0.0 (the default), the switch automatically selects a source IP
address from one of its active interfaces. If you use this setting, you must
add each of the switch IP addresses to the Client file on the RADIUS server
since you are not manually setting the source IP address.
Syntax
Sample Output
The following command sets the source IP address to 192.168.1.1:
(configure)#
set radius authentication source-ip 192.168.1.1
Systems
P550R, P580, P880, and P882.
To Configure
set radius authentication source-ip <ip-addr>
To Clear
clear radius authentication source-ip
Table 24-6. Parameters, Keywords, Arguments
Name
Definition
<ip-addr>
IP address that is used as the source IP address for Access Request
messages.