Set console databits, Command mode, Description – Avaya P580 User Manual
Page 83: Syntax, Sample output, Systems, Set console databits -3
Document No. 10-300090, Issue 1
5-3
Console
set console databits
Command Mode
Global Configuration.
Description
Sets the console serial port’s databit width. The default value is 8.
* Note:
This command is not applicable when the console serial port is
configured in PPP mode. The input will not be accepted or
stored when the console serial port is configured in PPP mode.
However, if the console serial port is configured as TTY mode
and the databits width is configured, the console serial port can
be changed to PPP mode and the databit width is saved until
TTY mode is restored.
Syntax
set console databits {7 | 8}
Sample Output
This example sets the databit width for the console serial port to 7.
(configure)#
set console databits 7
Systems
P550R, P580, P880, and P882.
Table 5-2. Parameters, Keywords, Arguments
Name
Definition
{7 | 8}
This is a required parameter. The number indicates the number
of bits used in the data stream.