LevelOne KVM-9006 - Manual (Page 10)

8
3 Hardware Installation
3.1 Installation Diagram
It is recommended to power off all the computers and server before the
installation. If it is difficult to turn off the computers, for PS/2 computer,
connect the Transmitter KVM-9006T and KVM-9006R in the following order:
first the PS/2 mouse connector followed by PS/2 keyboard connector, and
then the VGA connector to the computer.
1. Refer to the figure below. Turn the KVM-9006T / KVM-9006R upside
down and plaster it with the four accompanied rubber food pads.
2. Make sure the CAT5 cable is straight through type.
3. Plug one end of CAT5 cable into RJ-45 connector of the KVM-9006T,
and plug the other end of CAT5 cable into RJ-45 port of KVM-9006R.
4. Connect keyboard, mouse and monitor to the KVM-9006T
/KVM-9006R console ports (USB Keyboard/Mouse ports and VGA
port).
5. Connect local computer to KVM-9006T / KVM-9006R with the
accompanied 3-in-1 VGA cable (see section “3-in-1 VGA Cable
Installation” for detailed description).