LevelOne KVM-9006 - Manual (Page 12)

10
4 Operations
4.1 Keyboard Hotkey Commands
You can switch the KVM-9006R between “Local Host” port and “RJ-45” port
through simple key sequences made by the remote console side. To send
commands to the KVM-9006R, you must press the hotkey (default is
Scroll Lock) twice within 2 seconds. You will hear a beep sound confirming
you are in the hotkey mode. Then you have to enter command in 2 seconds.
If you do not press any key during hotkey mode over 2 seconds the hotkey
mode will be terminated and back to normal state.
Example:
The table below lists all the supported hotkey commands.
Command Function
C To switch between Local and Remote ports
Q To turn the beep sound on or off
S
To activate the Auto-Scan function. Auto-scan Remote
and Local port every 8 seconds repeatedly.
A For auto-adjust video signal of remote port to optimum
+ +
Scroll
Lock Scroll
Lock
C =
Switch between Local and Remote Site
Default Hotkey: Scroll Lock