LevelOne KVM-9006 - Manual (Page 13)

11
5 Troubleshooting
Make sure that all cables are well seated. Label all cables with the
name/number for each respective computer to avoid confusion.
Q: KVM-9006 (Transmitter) or KVM-9006R’s LED is not ON.
 Make sure the computer connected to KVM-9006T or KVM-9006R is
power on.
 Make sure the cable connected to KVM-9006T or KVM-9006R is well
seated.
Q: No video signal is displayed on the monitor.
 Make sure the power adapter is connected to the KVM-9006R .
 Make sure the VGA cable and CAT5 cable are properly connected to
the connectors.
 Make sure the VGA cable is attached to computer before the boot-up
process.
Q: The computer has started up, but keyboard or mouse doesn’t work.
 Make sure your keyboard and mouse work fine if directly plugged into
the computer.
 PS/2 Computer: Keyboard and mouse are not hot pluggable. Make
sure the PS/2 cables are well connected then reboot the computer.
 USB Computer: Unplug and plug in the USB connector, wait few
seconds for USB bus emulations and start up process to complete.
 Do not press any keys on keyboard while the selected computer is
booting up. Otherwise it might cause keyboard error or keyboard is
not detected by the Host side.
 Try a different keyboard, but use only 101/102/104-key keyboard.