LevelOne HVE-9900 User Manual
Page 8
7
Note for EDID (Extended Display Identification Data) learning
1. Don’t plug in HDMI cable to [HDMI In] when you want to restore default EDID or learn the
display’s EDID.
2. Please connect the display which you want to read EDID to HDMI OUT so the HVE-9002
can learn the EDID information from the connected HDTV.
3. To learn EDID from HDMI display, pull up-and-down the DIP switch 1 from OFF to ON, the
green light will dim and light to indicate the EDID learning process is complete. You
DON’T NEED to pull up the DIP switch again unless you want to learn another EDID by
pulling DIP switch 1 up and down.
Note
1
If the HDTV shows video but without audio, please try to set audio mode to stereo.
2
Factory default: Pin#1-OFF[©], Pin#2- OFF[©] for 1080p with stereo.
3
If you encounter any unsolved audio/video output problem during system installation,
please turn to Safe Mode (Pin#1-OFF[©] & Pin#2-ON[ª]) to enforce the most compatible
720p stereo output for system check.
4
Bypass means the matrix will maintain playing the original format of HDMI signals in video
and perhaps audio. By setting at this mode, the users may encounter compatibility issue
among different kinds of HDMI sources and displays. If you cannot get the audio and/or
video output normally at the system installation, please change the DIP switch setting to
default mode or even safe mode to verify the functionality of the device.
5
Set Pin#1 at ON[ª] first then connect the HDMI Input to HDTV through a HDMI cable. Wait
for 20 seconds. The EDID learning procedure will be finished. If you want to learn the EDID
from another HDTV, you must set Pin#1 at OFF first and repeat this procedure.