Staub Electronics EP-400-NMC EPISODE - RACK MOUNT UPS NETWORK MANAGMENT CARD - Manual (Page 17)

Remote Management System
17
RESET
[System->FTP service] Allows you to enable/disable the FTP server service and configure the
TCP/IP port of the FTP server (21 by default).
Note : The FTP server is used for upgrading Firmware. For more details on the upgrade process
please refer to “Firmware Upgrade” section of this Manual.
[System->Preference]
Allows you to select the temperature unit (Celsius/Fahrenheit).
[System->About] Displays vital information for the Remote Management Card.
Items Definition
Model name Model name of the Remote Management Card
Firmware version
The revision numbers of the firmware currently
installed on Remote Management Card.
Firmware updated date The date the firmware was last updated.
Hardware revision
The hardware version for the Remote Management
Card.
MAC address
MAC address for the Remote Management Card.
Note: the MAC address is also listed on the top of the
Remote Management Card .
Reset to Default Setting / Recover from a Lost Password
To reset the Remote Management Card to its default setting (including WEB log-in user name
and password), please use the following steps:
1. Remove the two retaining screws on the card without turning off the UPS.
2. Uninstall the card.
3. Take off the jumper on the Reset pins as illustrated.(The jumper is still necessary after reset ,
please do not lose or dispose of it)
4. Re-install the card into the expansion port.
5. Wait until the Green LED is flashing (the frequency of the ON/OFF flashing is one second).
6. Uninstall the card again.
7. Place the jumper back onto the Reset pins.
8. Install card into the expansion port again.
9. Tighten the retaining screws.