Hardware setup, Stacking and mounting, Stacking – ATEN CS428 User Manual
Page 15: Rack mounting, Stacking rack mounting, Chapter 2, hardware setup, Chapter 2
7
Chapter 2
Hardware Setup
Stacking and Mounting
The CS428 can be placed on the desktop or it can be rack mounted, as
described in the sections that follow.
Stacking
The unit comes with the stacking brackets already attached. To stack additional
units, simply line up the brackets on the top and bottom units, then fit the top
unit down onto the bottom unit.
Rack Mounting
The CS428 can be mounted in a 1U system rack. To rack mount the unit, do
the following:
1. Remove the stacking brackets by unscrewing them from the unit, as shown
in the diagram below:
1. Important safety information regarding the placement of this
device is provided on page 25. Please review it before
proceeding.
2. Make sure that power to all the devices you will be connecting
up have been turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.
cs428_2007-05.book Page 7 Thursday, May 17, 2007 5:08 PM