ATEN CS428 - Manual (Page 18)

CS428 User Manual
10
To set up a two stage installation, do the following:
1. Make sure that power to all the devices you will be connecting up,
including all preexisting devices on the installation, have been turned off
(unplug the power cords of any computers that have the Keyboard Power
On function; unplug the First Stage unit).
2. Use a 2L-1601P KVM Cable set (see Cables, page 3), to connect any
available KVM port on the CS428 (First Stage unit) to the Console Port
connectors of the Second Stage unit.
3. Use KVM Cable sets (see the Cables section of the Second Stage unit's
user manual for details), to connect any available KVM port on the Second
Stage unit to the keyboard, monitor, and mouse ports of the computer you
are installing.
4. Repeat steps 1 - 3 for any other Second Stage units you wish to connect.
5. Plug in the power adapter cable for the First Stage Master View unit's
Power Jack.
6. For each Second Stage unit, plug the power adapter into an AC source;
plug the power adapter cable into the Master View's Power Jack.
7. Power on the First Stage CS428.
8. Power on all Second Stage units
9. Plug in the power cords and power On all the computers.
Note: You must follow the sequence in steps 5 - 9 when powering up.
1 2 3 4 5 6 7 8
cs428_2007-05.book Page 10 Thursday, May 17, 2007 5:08 PM