ATEN CS428 - Manual (Page 16)

CS428 User Manual
8
2. Use the screws that came with the rack mount kit to screw the mounting
brackets into the sides of the unit, as shown in the diagram below:
3. Slide the unit into the rack and secure it to the rack.
Single Station Installation
The most basic installation is a Single Stage installation, in which no additional
Master Views are cascaded down from the first unit. To set up a single stage
installation, refer to the installation diagram on the following page (the
numbers in the diagram correspond to the numbers of the steps) as you perform
these steps:
1. Plug the keyboard, monitor, mouse microphone and speaker cables for
Consoles 1 and 2 into the console port connectors located on the CS428’s
rear panel. Each port is labeled with an icon to indicate itself.
Note: Use of microphone and speakers is optional.
2. Use the 2L-1701S KVM cable sets included with this package to connect
the components that make up Consoles 3 and 4 to Console ports 3 and 4 on
the rear panel of the CS428 unit.
3. Use 2L-1701S KVM cable sets (see Cables, page 3), to connect any
available KVM port to the keyboard, monitor, and mouse ports of the
computers you are installing.
4. Plug the power adapter into an AC source; plug the power adapter cable
into the 's Power Jack.
5. Turn on the power to the CS428.
cs428_2007-05.book Page 8 Thursday, May 17, 2007 5:08 PM