Osd navigation – ATEN CS428 User Manual
Page 23
4. OSD Operation
15
OSD Navigation
To dismiss the menu, and deactivate the OSD, Click the X at the upper
right corner of the OSD Window; or press [Esc].
To Logout, click F8 or the
ZZ
Z
symbol at the top of the Main Screen, or
press [F8].
To move up or down through the list one line at a time, Click the Up and
Down Triangle symbols (ST) or use the Up and Down Arrow Keys. If
there are more list entries than there is room for on the Main Screen, the
screen will scroll.
To move up or down through the list one screen at a time, Click the Up and
Down Arrow symbols (ÏÐ), or use the [Pg Up] and [Pg Dn] keys. If there
are more list entries than there is room for on the Main Screen, the screen
will scroll.
To bring the KVM focus to a port, Double Click it, or move the Highlight
Bar to it then press [Enter].
Note: 1. If you try to access a computer that has been designated as private
(see PRIVATE MODE, page 23), a message appears to inform
you that the Port is in Private Mode. In this case, the screen is
blank, and the port can neither be viewed, nor accessed.
2. If you try to access a computer that is already being accessed by
another Console, a message displays to inform you that the Port
is In Use. The target computer's screen can be viewed, but you
cannot give it any input until the Console that already has control
stops accessing it.
3. In a cascaded installation, if a computer attached to a Second
Stage swtich is already being accessed by another Console, that
computer and all the other computers attached to the same Second
Stage unit are considered to be in use. None of them can be
viewed or accessed from your Console. This is so, because
accessing any one computer attached to a Second Stage unit ties
up the entire CS428 Port that the unit is cascaded down from.
Only after the original Console no longer has access - either
because it relinquishes access, or because the timeout delay (see
SET LOGOUT TIMEOUT, page 21), has been exceeded - can
these computers be controlled from another Console.
After executing any action, you automatically go back to the menu one
level above.
cs428_2007-05.book Page 15 Thursday, May 17, 2007 5:08 PM