Steelcraft Automotive 52250 GRILL GUARD - Manual

Page 1 of 5 12/30/08 Rev2(DP)
PARTS LIST:
Qty Description Qty Description
1 Grille Guard 8 12-1.75mm x 35mm Hex Bolts
2
Upper Frame Mounting Brackets (for trucks without
tow hooks only)
22 12mm x 30.1mm OD x 3.1mm Flat Washers
1 Driver/Left Lower Frame Mounting Bracket 14 12mm Lock Washers
1 Passenger/Right Lower Frame Mounting Bracket 12 12-1.75mm Hex Nuts
1 Driver/Left Upper Support Bracket 2 8mm x 20mm Button Head Allen Bolts
1 Passenger/Right Upper Support Bracket 4 8mm x 22mm OD x 1.5mm Flat Washers
1 Driver/Left Lower Support Bracket 2 8mm Lock Washers
1 Passenger/Right Lower Support Bracket 2 8mm Hex Nuts
2
12-1.5mm x 30mm Fine Thread Hex Bolt (for trucks
without tow hooks only)
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED.
ASSISTANCE IS RECOMMENDED.
2. Starting at the underside of the front bumper, carefully remove the plastic splash guard. NOTE:
Depending on the model of truck, the splash guard may be attached to the bottom of the truck with
hex bolts and several two-piece plastic push-in clips. NOTE: Pay close attention to the type and
location of all factory hardware for reinstallation. First, remove all hex bolts then locate the clips
behind the bumper cover, (Figure 1A). Pry up on the center pin of the clip with a small flat blade
screwdriver and remove the entire clip, (Figure 1B). The splash guard may also be attached to
the bumper cover with rivets or hex bolts at the corners. NOTE: If the splash guard is fastened
with rivets, first remove all of the other fasteners from the splash guard. Hold the bumper cover in
place and firmly pull the splash guard from each rivet. Remove the rivets from the bumper cover
and move the splash guard to a clean stable work area.
3. From underneath the front of the vehicle, determine if the truck is equipped with or without tow
hooks.
INSTALLATION INSTRUCTIONS
GRILLE GUARD
09-ON DODGE RAM
PART #
Passenger Side
Lower Frame
Mounting
Bracket
Driver Side Lower
Frame Mounting
Bracket
Passenger Side
Lower Support
Bracket (see note)
Upper Frame
Mounting
Bracket (use on
trucks without
tow hooks only) Upper Frame
Mounting
Bracket (use on
trucks without
tow hooks only)
Driver Side Lower Support Bracket
(Support Brackets pictured in position
for installation on tow hook equipped
vehicles. Reverse direction for
vehicles without tow hooks)
Passenger side Upper
Support Bracket
Driver side Upper
Support Bracket