Steelcraft Automotive 52250 GRILL GUARD - Manual (Page 5)

Page 5 of 5 12/30/08 Rev2(DP)
Driver Side Installation Pictured
Do not cut through
the front or rear
edge of the splash
guard
Fig 10
If required, replace the rivet
at the corner of the splash
guard with the supplied:
6mm x 20mm Button Head
Allen Bolt
(2) 6mm Flat Washers
6mm Nylock Hex Nut
Fig 9
12-1.75mm x 35mm Hex Bolts
12mm Flat Washers
12mm Lock Washers
12mm Hex Nuts
Front
Passenger side
Support Bracket in
"with Tow Hook"
position
Passenger side
Support Bracket in "No
Tow Hook" position
Front
Hold the splash
guard up to the
brackets and mark
location for cutting to
clear brackets. Cut
only what is needed
to insert bracket
through the splash
guard. To maintain
strength, it is not
necessary or
recommended to cut
through the front or
rear edge of the
splash guard.
Fig 8
Fig 11
Fig 12
Fig 13 Fig 14
Installation pictured
without the splash
guard for illustration
(1) 8mm x 20mm Button
Head Allen Bolt
(2) 8mm Flat Washers
(1) 8mm Nylock Nut