Steelcraft Automotive 52200 GRILL GUARD - Manual (Page 2)

GRILLE GUARD
07-12 JEEP J/K WRANGLER
Page 2 of 4 3/27/12 Rev2(DP)
8. With assistance, lift the Grille Guard up to the inside of the Frame Mounting Brackets. Line up the holes in
the Frame Mounting Brackets with the holes in the Grille Guard. Insert (6) 12-1.75mm x 30mm Hex Bolts,
(12) 12mm Flat Washers and (6)12mm Nylon Lock Nuts, (Figure 8). Push the grille guard back into an
upright position. Secure the Top Brackets to the grille guard with the included (2) 10mm x 30mm Button
Head Allen Bolts, (4) 10mm Flat Washers and (2) 10mm Nylon Lock Nuts, (Figure 9). Adjust the Brackets
as necessary then snug but do not tighten all of the hardware.
9. Stand back from the vehicle and check to see that the Grille Guard is centered and level on the vehicle and
adjust as required. It may be necessary to slightly loosen the Frame mounting brackets to properly align
the Grille Guard. IMPORTANT: Once properly aligned, tighten all of the hardware.
10. Do periodic inspections of the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Grille Guard.
For gloss black finishes: Mild soap may be used to clean the Grille Guard.
Passenger Side Installation Pictured
Fig 1A
2010-12 Passenger side Frame Mounting Bracket
bolts to the inner mounting location (pictured
with Grille Guard in position for example only)
Fig 1C
07-09 Passenger side Frame Mounting Bracket
bolts to the outer mounting location (pictured
with Grille Guard in position for example only)
Fig 1B
2007-12 Driver side Frame Mounting
Bracket installation (pictured with Grille
Guard in position for example only)
12mm x 30mm Hex Bolt
(2) 12mm Flat Washers
12mm Nylon Lock Nut
12mm x 30mm Hex Bolt
(2) 12mm Flat Washers
12mm Nylon Lock Nut
Front
Front
Front