Steelcraft Automotive 52200 GRILL GUARD - Manual (Page 3)

GRILLE GUARD
07-12 JEEP J/K WRANGLER
Page 3 of 4 3/27/12 Rev2(DP)
Driver Side Installation Pictured
Fig 3
Fig 5
Fig 2
12mm x 30mm Hex Bolt
(2) 12mm Flat Washers
12mm Nylon Lock Nut
Insert (1) 8mm Rod Bolt up
through opening in corner,
hole in Top Bracket and out
hole in side of frame upright
Reinstall the fill panel and mark the cut area on the
bottom of the panel straight up from the frame upright.
Start with a small opening and slowly enlarge the
opening to get the best fit around the brackets. Area
cut from fill panel pictured for example only.
Frame upright
(Fig 4) Pictured without fill plate for example only
(Fig 6) 2012 only: It may be a little easier to
install the 8mm hardware on Rod Bolt if you
temporarily move this factory valve out of
the way-do not remove or disconnect
Insert Bracket into the
opening and bolt in place
with special Rod Bolt
8mm Flat Washer
8mm Nylon Lock Nut
Open end wrench
Front
Front
Front
Front