Teka LP7 830 - Manual (Page 21)

Delayed start programming
You can delay the start of a programme in increments of one hour up to 12 hours.
Switch dishwasher ON.
Immediately press the Delayed Start button “ D ”, the delayed start indicator “ E ” blinks, the delayed
start time indicator “ F ” changes to “ ”.
Press the Delayed Start button “ D ” as many times as necessary until the numerical display shows
the required delay.
To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator “
E” goes out.
Press programme button “ J ” to choose the desired programme.
D
E
F
If the the door is closed, after 5 seconds the delayed start indicator “ E ” lights , the time-remaining
indicator “ F ” will blink and decrease , the programme will start until the delayed start indicator “ F ”
goes out .
J
Interrupping the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
20
en