Teka LP7 830 - Manual (Page 22)

Cancelling or modifying a cycle
A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the
detergent ”).
To modify a cycle that is already underway, press the button“ A ” , all of the settings will be cancelled.
To set a new cycle, follow the instructions contained in the paragraph entitled “Switching the dish-
washer ON”.
1/2 Load Button
This button E (see" Close-up View (Control Panel), letter " B ") makes it possible to wash dishes using
only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and
energy consumption.
To select 1/2 load:
Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”)
Press the 1/2 load button “ B ” , 1/2 load indicator “ C ” blinks.
If the door is closed, after 5 seconds, the programme starts automatically.
- Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.
- To cancel the 1/2 load, you can press the 1/2 load button “ B ” again ,until the 1/2 load indicators
“ C” goes out.
A
B
C
21
en