Teka HPL 830 - Manual (Page 27)

27
ENGLISH
13. Open the oven door and wipe the inside
with a damp cloth, cleaning up the ash
from the cleaning cycle. Hard-to-reach
areas in the oven will need to be cleaned
with a non-metallic fibre scourer.
14. Once the oven is clean, remember to
replace the suppor ts and accessories.
15. The oven is now ready to be used.
IMPORTANT: If any incidents are detected in
the programming and operating of this func-
tion, consult the section “Incidents while
Operating the Pyrolytic Function”.
CANCELLING THE PYROLYTIC CYCLE
Pyrolysis is an automatic function and there-
fore can only be activated from the timer pro-
gramme. To cancel a cleaning cycle it is neces-
sary to reset the oven, following the instruc-
tions below:
1 Set the function control at and wait for
1 minute.
2 Unlock the oven door.
1 Set the function control at and wait for
1 minute. The oven will no longer heat up.
2 Unlock the oven door. To cancel the clean-
ing cycle, the oven door must be unlocked.
To do so, consider the following:
a) Unlocking the door 45 minutes after
the cleaning cycle. If the oven has been
operating for more than 45 minutes, the
door will unlock automatically once the
oven has cooled down to the safe temp-
erature. Then, pilot light
will switch
off.
b) Unlocking the door in the first 45 min-
utes (at a low temperature). Within the
first 45 minutes the oven door will
unlock automatically. Follow the instruc-
tions below:
1 Turn the control dial to position .
2 Wait for approximately 1 minute.
3 Turn the control dial to position .
4 Approximately, 1 minute later pilot
light will turn off and the oven door
can be opened.
3172492-001 EPIFA.QXD:- 29/8/11 12:17 Página 27