Teka HPL 830 - Manual (Page 28)

28
INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT CAUSE SOLUTION
My accessories and shelf
suppor ts are damaged. You have not removed the
accessories and supports during
the pyrolytic cleaning cycle. You must replace them and
remove them in later cleaning
cycles.
The enamel colour has
changed and stains have
appeared. The chemical composition of
some foodstuffs may cause
changes in the enamel. This is normal and does not
damage the proper ties of the
enamel.
The oven door is locked, pilot
light
is lit up but the oven
is not hot.
You have turned the control
dial to position
and no
other additional operation has
been per formed.
Switch off the oven and follow
the instructions to unlock the
door in the first 45 minutes at
a low temperature.
Next, select the pyrolytic
function, carefully following the
instructions.
I have turned the control dial
to position
and selected
a pyrolisis programme (P1, P2
or P3) but the pilot light
has not lit up and the oven is
not heating up.
The oven door has not been
closed properly so it cannot
be locked automatically. Check the door and make
sure that it is closed properly.
I have turned the control dial
to position
and selected
a pyrolisis programme (P1, P2
or P3) but the pilot light
has not lit up and the oven is
not heating up.
The door switch is not working
even though the door is
properly closed. Call Technical Assistance
Ser vice as there is a fault in
the door switch.
I have programmed the
pyrolysis function, the oven is
working properly but pilot light
is not lit up.
Pilot light does not work
properly.
Call the Technical Assistance
Ser vice.
The pyrolysis programme has
ended and the oven is cold,
but the door is locked and
symbol is
flashing.
You did not turn the control
dial to position
when the
pyrolysis programme ended.
1. Turn the control dial to
position and wait for 1
minute.
2. Turn the control dial to
position and wait for 1
minute.
3. Turn the control dial to
position again and wait
until pilot light turns off.
3172492-001 EPIFA.QXD:- 29/8/11 12:17 Página 28