Teledyne LeCroy HFP1500 - Manual (Page 43)

Operator’s Manual
922252-00 Rev A 37
A USTRALIA & N EW Z EALAND D ECLARATION OF C ONFORMITY
—EMC
The probe complies with the EMC provision of the Radio Communications Act per the following
standards, in accordance with requirements imposed by Australian Communication and Media
Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with EN61326-
1:2006 and EN61326-2-1:2006.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC D ECLARATION OF C ONFORMITY
–
L OW V OLTAGE
The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 2-030: Particular requirements for testing and measuring circuits
EN 61010-031/A1:2008 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 031: Safety requirements for hand-held probe assemblies for electrical
measurement and test.
Environmental Compliance
E ND -O F -L IFE H ANDLING
The probe is marked with this symbol to indicate that it complies with the applicable
European Union requirements to Directives 2002/96/EC and 2006/66/EC on Waste
Electrical and Electronic Equipment (WEEE) and Batteries.
The probe is subject to disposal and recycling regulations that vary by country and
region. Many countries prohibit the disposal of waste electronic equipment in standard
waste receptacles. For more information about proper disposal and recycling of your
Teledyne LeCroy product, please visit teledynelecroy.com/recycle.
R ESTRICTION OF H AZARDOUS S UBSTANCES (R O HS)
This probe has been classified as Industrial Monitoring and Control Equipment and is outside the
scope of the 2011/65/EU RoHS Directive until 22 July 2017 (per Article 4, Paragraph 3).